Mares Puck - Setting Puck Dive Computer Parameters; Watch and Display Settings

30
BACKLIGHTING
Pressing the button for 4 seconds will temporarily
turn on the backlight (for about 4 seconds).
When the backlight is on, pressing the button will
prolong illumination of the display.

WARNING
Temperature can noticeably affect battery
voltage.
The icon that signals a low battery level
may appear due to low temperatures, even
if the battery still has sufficient capacity. In
this case, backlighting is disabled.
If backlighting has been disabled due to low
temperature, you can repeat the battery status
check by entering SYSTEM mode.
If the battery icon disappears, the backlighting
function has been re-enabled.

WARNING
We advise that you replace the battery if
you intend to dive in cold water.
AUTOMATIC SWITCHOFF
If PUCK is turned on but no button is pressed
for a certain period of time, it will turn off
automatically. The delay before automatic switch-
off varies depending on the current operating
mode.
SETTING PARAMETERS FOR
THE PUCK COMPUTER
ADJUSTING THE WATCH:
WATCHSET
The WATCHSET menu is divided into three
submenus, where you can adjust the following
parameters:
• ADJ TIME
- Time
- Watch display (12h-24h)
- Date
• CONTRAST
- Display contrast
• KEY BEEP
- Enable/disable the beep that sounds
when the button is pressed
Scroll through the main menu and move to
WATCHSET.
To enter the WATCHSET menu, press and hold the
button. The words ADJ TIME will appear.
WATCHSET  ADJ TIME
When the words ADJ TIME appear, press and hold
the button.
The minutes number will flash.
Press the button to increase the minutes.
Press and hold the button to save the current
minutes value.
The hour number will flash.
Change and set the number using the same
procedure as for the minutes.
In sequence, the other information displayed is:
• Minutes
• Hour
• Time Format
• Year
• Month
• Day
Setting the day returns you to the ADJ TIME menu.
Press the button to move to the CONTRAST menu.
WATCHSET  CONTRAST
Press and hold the button to enter this mode. The
current contrast value will flash. Press the button
to increase the contrast (maximum value 15).
Press and hold the button to select the desired
value.
WATCHSET  KEY BEEP
Press and hold the button to enter this mode. The
current value, ON or OFF, will flash.
Press the button to change your selection.
Press and hold the button to confirm your
selection.
Press the button to move to the ESC position
(Figure 4).