Series DC Digital Controllers
12
5.4 Dwell Time
This setting corresponds to the amount of time, in seconds, for which the test
stand stops at the limit during a cycle sequence. Independent dwell times can
be set for both limits.
Note: the dwell time setting is unavailable for an auto return sequence.
Default setting: 0 (no dwell time)
Available settings: 0 – 9999.9
+
Increases the number of cycles in
increments of 1. Holding down + will
increment at an increasingly faster rate. If
99999 is reached the next number will be
00000 and continue incrementing.
–
Decreases the number of cycles in
increments of 1. Holding down – will
decrement at an increasingly faster rate. If
00000 is reached the next number will be
99999 and continue decrementing.
Press and hold
+ and –
simultaneously
If pressed and held for two seconds or
longer the number of cycles will change to 0.
ENTR
Returns to the Test Parameter Setup menu
ESC
Exits the parameter without saving changes
DWELL U: 0000.0
ESC ENTR
+
_
To Next Page
Loading...
Need help?
General
