1. Preface
This manual provides detailed instructions on the use of the UNITY-xr. It details the software/hardware
interface and procedure for the installation of this instrument.
1.1 Notices
No part of this manual may be reproduced in any form or by any means (including electronic storage and
retrieval or translation into a foreign language) without prior agreement and written consent from Markes
International.
Please note that the material contained in this document is subject to being changed, without notice, in
future editions. Markes International shall not be liable for errors or for incidental or consequential
damages in connection with the supply, use or performance of this document or of any information
contained herein, unless a separate agreement between Markes International and the user should take
precedence.
1.2 Warranty
UNITY-xr is designed for laboratory use only. It is not intended for use in domestic establishments or
establishments directly connected to a low-voltage power supply network that supplies buildings used for
domestic purposes. Where equipment is used in a field placement environment, care must be taken to
ensure that the instrument is not exposed to detrimental conditions, i.e. rain, wind, or sun. Exposure may
diminish the performance, cause damage to the instrument and/or cause the equipment to become
unsafe to the user.
If the equipment is not used in a way specified by Markes International, the safety protection provided by
the equipment may be reduced. Furthermore, system failures arising from such use may not be covered in
standard warranty and/or service contract agreements.
1.3 Regulatory compliance
The instrument is designed and manufactured under a quality system registered to ISO 9001.
The instrument complies with the essential requirements of the following applicable European Directives,
and carries the CE mark accordingly:
o Low voltage Directive 2014/35/EU
o EMC Directive 2014/30/EU
o ROHS Directive 2011/65/EU
The instrument conforms to the following product safety standards:
o IEC 61010-1/EN 61010-1
o Canada: CSA C22.2 No.61010-1
o USA: ANSI/UL 61010-1.
The instrument conforms to the following regulation on electromagnetic compatibility (EMC):
o IEC 61326-1/EN 61326-1.
To Next Page
