marklin 24802 User Manual

9
CV Programming
CV programming must be done on the programming track.
We recommend creating a fictitious locomotive for pro-
gramming purposes. Values in parentheses are the factory
settings.
The turnout lantern connected to the digital installation
decoder will blink as a control check during the data trans-
mission. The programming can be done optionally with fx
(MM) or DCC. In fx (MM), we recommend setting the address
by means of DIP switches (see 30ff).
fx (MM) / Motorola
Before doing any programming, the turnout to be program-
med must be switched with the Keyboard. After that, the CVs
can be changed as desired immediately with the Control Unit
or the CV configuration on the Central Station. Immediately
after that, switch the newly programmed turnout again with
the Keyboard. At this point the programming is accepted and
is functional.
CV Meaning Values
8 Decoder reset 8 (-) factory setting, not
written value is
36 Turnout lantern
off/on
0-1 (1)
The procedure for programming with the 6021 Control Unit is
the same as locomotive programming (www.maerklin.de ->
Service -> Technische Informationen).
DCC
CV Meaning Values
1 Address, lower value
Byte
0-255
7 Manufacturer version
number (software
version)
(-) read only
8 Manufacture recogniti-
on ID Decoder reset
(131)
8 (-)
read only,
factory setting, value
is not written
9 Address, higher value
Byte
0-7 (0)
29 Configuration (192) read only
Bits 0-4 are not used 0
Bit5:Decodertype 0 / 32 basic or advanced
accessory decoder
Bit6:Addressing
method
0 / 64
decoder or output
address
Bit7:Decodertype 128 accessory decoder
36 Turnout lantern, off/on 0-1 (1)
Setting and generating addresses larger than 255:
Example:Address1044->1044:256=4,078125.Thevalue
before the comma (4) is to be entered in CV 9. The value after
thecomma(0,078125)ismultipliedby256,078125x256=20.
The value of 20 that is generated must be entered in CV 1.

marklin 24802 Specifications

General

Brand	marklin
Model	24802
Category	Toy
Language	English