MARS DRINKS AROMA™ User Guide
10
a. NOTE: The drip tray can be removed to make space for taller cups or
repositioned higher for shorter cups. Reference “Selecting Your Cup”
on page 8.
4. Select your drink or soup of choice using the drink selection buttons on the
user interface panel. Press the corresponding button once. Your drink of
choice will illuminate and all other indicator lights will turn off.
5. When brewing is complete, all of the drink selection indicator lights will
come back on.
6. Once brewing is complete, slide the handle from left to right to open the
door and remove the used Freshpack for disposal.
7. Enjoy!
CAUTION: Take care when removing the Freshpack immediately after the brewing
process as it will be HOT.
After each vend, the brewer will heat water up to the optimum temperature for
the next drink to be brewed. There may be a short delay before the next
beverage can be brewed. When the brewer is ready, all of the indicator lights will
remain on.
Do not open the pack door, attempt to remove the pack or press drinks
selection buttons before brewing is complete, this will interrupt the
brewing process.
Pressing the drink selection button during brewing will interrupt the
brewing process. The brewer will NOT complete an interrupted brew.
Take care when removing the Freshpack after an interrupted brew as it will
be HOT, and may drip HOT water.
Do not remove the cold tank from the brewer during brewing as this will
reduce the volume of the drink and subsequent drinks brewed.
To Next Page
Loading...