MARS DRINKS AROMA™ User Guide
7
Setting Up Your Brewer
Quick Start
When you’ve identified a stable, level surface capable of safely supporting the
weight, place your brewer and follow these steps for quick set-up:
1. Remove the packaging tape from the drip tray and cold tank. Ensure the
drip tray and tank are in place.
2. Fill the cold tank with filtered water and
replace the lid. The tank can be removed for
easier filling. Ensure it’s correctly repositioned.
3. Plug in the power cord and press the power
button. The power button will illuminate.
4. All drink selection buttons will stay lit when
the water is heated.
5. Before enjoying your first drink, we
recommend flushing the system. Place a cup on the stand. Press and hold
the hot water button until the cup is full. Discard the water.
Now, you’re ready to brew!
Filling the Cold Tank with Water
When the brewer requires refilling with water, the WATER diagnostic light will
flash. The cold tank can be filled with a jug or detached from the brewer and
filled directly from a faucet.
Carefully fill the cold tank with filtered drinking water. Do not overflow the tank.
The volume of water required to fill the brewer is 81floz (2.4L). During operation
the water level may be monitored via the water level indicator on the front of the
brewer.
Filtered Water for the Finest Tasting Beverages
For a great tasting hot beverage in every cup we recommend the use of filtered
water, not softened. Substances such as chlorine, present in unfiltered water,
could impair the flavor and aroma of your hot beverage.
The use of filtered water will also help to protect your brewer and extend its life.
To Next Page
Loading...