MARS DRINKS AROMA™ User Guide
11
How to Make a Cappuccino or Latte
Cappuccino and latte drinks are made using two packs, firstly a froth pack
followed by the coffee or tea of your choice. It is important that the packs are
placed in the correct order. Please see the packs for further information.
1. Slide the handle from left to right to open the door. Place a froth or hot
chocolate Freshpack inside with the nozzle pointing up.
2. Slide the handle from right to left to close the door. The DOOR diagnostic
light will illuminate if not closed fully.
a. NOTE: Some resistance may be felt as the pack door is closed. This is
normal. This step is piercing the pack seal.
3. Place your cup onto the drip tray and push back until it touches the
backstop.
a. NOTE: The drip tray can be removed to make space for taller cups or
repositioned higher for shorter cups.
4. Select cappuccino or latte on the user interface. Your drink of choice will
stay illuminated and all other indicator lights will turn off.
5. When brewing is complete, the chosen drink indicator and the PACK
diagnostic light will flash.
6. Slide the handle from left to right to open the door and remove the used
Freshpack for disposal. Replace with a coffee or tea Freshpack of your
choice.
7. Slide the handle from right to left to close the door. Press the chosen drink
again. The indicator light will then stop flashing and stay illuminated while
the drink continues to brew.
8. When brewing is complete, all of the drink selection indicator lights will
come back on.
9. Once brewing is complete, slide the handle from left to right to open the
door and remove the used Freshpack for disposal.
10. Enjoy!
CAUTION: Take care when removing the pack immediately after the brewing
process as it will be HOT.
To Next Page
Loading...