MARS DRINKS AROMA™ User Guide
17
If the brewer is inactive for 2 hours it
will automatically turn off. Press the
power button to turn the brewer back
on.
The brewer does not brew beverages
after pressing selection button.
Ensure that the Freshpack is inserted
fully and that the pack door is fully
closed.
The brewer does not deliver hot
water after pressing and holding HOT
WATER button.
Ensure there is no pack inserted and
that the pack door is fully closed.
The pack door cannot be closed.
Check that the pack door is correctly
fitted to the Brewer. Refer to page 14
for further information.
NOTE: When closing the pack door
after inserting a pack, you will feel
some resistance. Closing the pack
door will pierce the seal of the
Freshpack and is perfectly normal.
The pack cannot be pierced.
Check that the pack is correctly
inserted, and that the pack door is
correctly fitted to the brewer.
The brewer makes a “pop” sound
shortly after the Selection button is
pressed.
Occasionally a “pop” may be heard at
the start of a beverage being brewed;
this is normal and is confirmation of
the optimal freshness of your
beverage.
The amount of beverage dispensed is
repeatedly too small/high and/or is
dispensing too slowly.
The internal parts of the brewer may
have become blocked with scale.
Refer to the descaling instructions on
page 14 for further information.
Water leaks from the brewer.
Ensure the pack door is fully closed
when brewing beverages.
Ensure the cold tank is not
overflowing.
Ensure the drip tray is not
overflowing.
To Next Page
Loading...