13
AUDITING YOUR BREWER
CONFIGURING ENERGY SAVING MODE
In order to conserve energy the brewer can be configured to switch to standby mode after a
specified time of inactivity. To configure the energy saving mode:
1. Enter Operator menu (push and hold bottom left and right buttons) (Ref. A, page 4)
2. Enter password (default password: press top right button 4 times) (Ref. B, page 4)
3. Press back / next to display the ‘standby timeout (mins)’ screen (Ref. L)
4. Set time period for brewer to enter standby in minutes by pressing Edit +/-
5. Press Exit menus
If brewer is inactive for the specified time it will enter standby mode. In this mode the heaters and
lights will be switched o and the display will be turned o. Pressing any button will re-active the
brewer.
DRAINING YOUR BREWER
Notice Make sure brewer is turned o
Draining is recommended before moving or storing the brewer.
1. Remove filterpack bin and drip tray
2. Remove drain tube access cover
3. Pull out drain tube and position over a waste water receptacle
4. Remove bung. CAUTION – WATER MAY BE HOT
5. Allow all water to drain out
6. Replace bung fully
7. Push drain tube back into place
8. Replace drain Tube Access Cover
9. Replace filterpack bin and drip tray
Edit>
Edit>
Standby Timeout (Mins):
240
<Back
Next
WATER HEATING
Exit Menus
(Ref. L)
To Next Page
Loading...