4
ENG
SETTING UP YOUR BREWER
SWITCHING ON
1. Plug your FLAVIA® barista in
2. Switch on using ON/OFF switch at back to Position “I”
(Ref. A)
Before you can use your brewer you must first configure your brewer and prime the hot water
system.
ENTERING OPERATOR MENU
Enter the Operator password (default password: press top right button 4 times) (Ref. B). The
Operator Menu navigation options “Next” and “Back” will appear (Ref. C)
(Ref. B)
Interim Total Cups:
00000016
PRIME HOT WATER SYSTEM
Exit Menus
<Back
Interim Total Cups:
00000016
<Next
PRIME HOT WATER SYSTEM
Exit Menus
(Ref. C)
SELECTING WATER SUPPLY
1. From the Operator Menu (Ref. C), press “Next”
until the menu item “Water Supply:” is shown
2. Select “Jug Filled” or “Plumbed In” using the
“Edit+” or “Edit –“ buttons
PLUMBED IN WATER SUPPLY
Select the “Plumbed In” option if the water supply to the brewer will come from the mains water
supply. In this case a water hose must be connected to the back of the brewer.
When using the brewer in plumbed in mode, the filler lid can be secured using the screws supplied.
Please refer to the instruction sheet supplied with the brewer.
IMPORTANT: Refer to “plumbed systems” in “SAFETY AND INSTALLATION GUIDELINES” section.
x4
1. Push the bottom left and right buttons
simultaneously and hold them for 2 seconds (Ref.
A). The lights of the bottom two buttons will
illuminate to show you have pressed the buttons
simultaneously. If the lights do not light up you may
not have pressed the two buttons at the same time.
If this is the case try again. After 2 seconds the
screen will change to show the Drink Audit Screen
( Ref B)
<Back Edit+>
Water Supply:
Plumbed-In
<Next Edit->
Exit Menus
To Next Page
Loading...
Need help?
General
