Remote Control Manual - PS-121B / PSH-141A
5
HOW TO USE THE BUTTONS
Auto Operation
Ensure the unit is plugged in and power is available.
The OPERATION indicator on the display panel of the
indoor unit illuminates.
1. Press the MODE button to select Auto.
2. Press the TEMP button to set the desired
temperature. The temperature can be set within
a range of 17°C(62°F)~ 30°C (86°F) in 1°C(2°F)
increments.
3. Press the ON/OFF button to start the unit.
NOTE:
1. In the Auto mode, the unit can logically choose
Cooling, Fan, and Dehumidifying modes by sensing
the difference between the actual ambient room
temperature and the set temperature on the remote
controller.
2. In the Auto mode the fan speed is automatically
controlled.
3. If the Auto mode does not heat or cool adequately
for personal comfort, the desired mode can be
selected manually.
Cooling / Heating / Fan Operation
Ensure the unit is plugged in and power is available.
1. Press the MODE button to select COOL, HEAT,
(PSH-141 model only) or FAN mode.
2. Press the TEMP button to set the desired
temperature. The temperature can be set within
a range of 17°C(62°F)~ 30°C (86°F) in 1°C(2°F)
increments.
3. Press the FAN SPEED button to select the
fan speed in four steps- Auto, Low, Med,or High.
4. Press the ON/OFF button to start the unit.
NOTE:
In the FAN mode, the setting temperature is not
displayed in the remote controller and you cannot
control the room temperature. In this case, only steps
1, 3 and 4 may be performed.
To Next Page
Loading...
Need help?
General
