Remote Control Manual - PS-121B / PSH-141A
7
HOW TO USE THE BUTTONS
Timer Operation
Press the TIMER ON button to set the auto-on time of
the unit. Press the TIMER OFF button to set the auto-
off time of the unit.
1. Press the TIMER ON button. The remote controller
shows TIMER ON, the last Auto-on setting time and
the signal “h” will be shown on the LCD display area.
The Auto-on time can now be reset to START the
operation.
2. Push the TIMER ON button again to set desired
Auto-on time. Each time you press the button, the
time increases in 30 minutes increments, up to 10
hours, then at 1 hour increments up to 24 hours.
3. After setting the TIMER ON ,there will be a
half second delay before the remote controller
transmits the signal to the unit. After approximately
2 seconds, the signal “h” will disappear and the
set temperature will re-appear on the LCD display
window.
To set the Auto-Off Timer
1. Press the TIMER OFF button. The remote controller
shows TIMER OFF. The last Auto-off setting time
and the signal “h” will be shown on the LCD display
area. The Auto-off time can now be reset to START
the operation.
2. Push the TIMER OFF button again to set desired
Auto-off time. Each time you press the button, the
time increases in 30 minute increments, up to 10
hours, then at 1 hour increments up to 24 hours.
3. After setting the TIMER OFF, there will be a
half second delay before the remote controller
transmits the signal to the unit. After approximately
another 2 seconds, the signal “h” will disappear
and the set temperature will re-appear on the LCD
display window.
To Next Page
Loading...
