1. POWER
This is the on/off switch for the mains
power to the amp. When power is
switched on, the switch will light red.
Warning: please ensure that the amp
is switched off and unplugged from the
mains electricity supply before being
moved.
2. OUTPUT
The output power is in low power mode
(5W) when set to low, when in the middle
position it is set to standby and when set
to high power the unit runs at full power
(20W).
Standby mode: should be used during
breaks in performances, instead of leaving
the amp on full power. Always turn the
power on for two minutes before using the
standby switch.
3. PRESENCE
Adjusts the high frequencies of the power
amp. Increasing the high frequencies adds
more bite to your sound.
4. BASS
Adjusts the low frequencies of the amp.
It will add bottom end and depth to your
sound.
5. MIDDLE
Adjusts the mid frequencies of the amp.
Giving you anything from a fat and full
sound to an aggressive tone.
6. TREBLE
Adjust the upper frequencies of the amp.
Your tone will get brighter as it is turned
up.
2525H (COMBO SHOWN ON NEXT PAGE)
ENGLISH
118 9 107
6
54321
3.0
FRONT PANEL FUNCTIONS
To Next Page
Loading...
Need help?
General
