7. OUTPUT MASTER / LEAD CHANNEL
The output master control adjusts the
output of the preamp section to the power
stage.
The lead channel is selected using the
footswitch (supplied PEDL-90003). The
channel can also be switched by using the
push/pull function of the output master
control. The amount of gain applied to the
lead channel can be controlled using the
input gain control (front panel function
10).
8. LEAD CHANNEL LED
The LED indicator will light and glow red
when the lead channel is selected.
9. LEAD MASTER
When the lead channel is active (front
panel function 7) the lead master control
adjusts the output level of the lead
channel.
10. INPUT GAIN
Adjusts the overall sensitivity of the input
circuit. It controls the gain level of the
clean/crunch rhythm clip mode and the
lead channel. The pull switch activates
rhythm clip mode, providing heavier, more
driven tones.
Note: the apparent drop in volume when
rhythm clip mode is selected may be
overcome by increasing the level of the
output master (front panel function 7).
11. INPUT
Use this jack socket to connect your guitar
to the amp.
2525C (HEAD SHOWN ON PREVIOUS PAGE)
ENGLISH
11 8910 7
6
5 4 3 2 1
3.0
FRONT PANEL FUNCTIONS CONTINUED
To Next Page
Loading...
