Need help?Do you have a question about the Marshall Amplification Haze MHZ40C and is the answer not in the manual?
General| Type | Tube Amplifier |
|---|---|
| Power | 40 Watts |
| Reverb | Yes |
| Effects Loop | Yes |
| Channels | 2 |
| EQ | 3-band EQ (Bass, Middle, Treble) |
| Footswitch I/O | 1 x 1/4" (Channel Switching) |
| Tubes | 3 x ECC83 (Preamp), 2 x EL34 (Power Amp) |
| Controls | Bass, Middle, Treble, Reverb |
| Footswitch | Optional |
| Speaker | 1x12" |
| Outputs | 1 |
Personal message from Jim Marshall and an overview of the Haze series amplifiers.
Guide to connecting power, fuses, guitar, and safely powering on the amplifier.
Instructions for using the Standby switch for the Haze 40W combo to warm up valves.
Details on input jack, bright, boost, channel switching, and volume/gain controls.
Explanations of EQ, Presence, Reverb Level, Effect Depth, and Effects Adjust controls.
Information on the Standby and Power switches for safe operation and valve warm-up.
Details on mains input, HT fuse, emulated line out, speaker outputs, effects loop, and footswitch socket.
Lists power, valves, channels, impedance, dimensions, and weight of the MHZ40C combo.
Details on the power switch, effect selection, effect depth, and reverb level controls.
Explanations of EQ, bass, middle, treble, gain, volume, and channel switching controls.
Information on the guitar input jack and the bright switch function.
Details on footswitch socket, speaker outputs, HT fuse, and mains input socket.
Lists power, valves, channels, impedance, dimensions, and weight of the MHZ15 head.
Recommended settings for Normal Boost (blues) and Normal Crunch tones.
Recommended settings for Overdrive (raw crunch) and Overdrive (lead) tones.
Recommended settings for high gain solo with reverb and delay.
To Next Page