EasyManuals Logo

Marshall Amplification STUDIO JTM ST20C User Manual

Marshall Amplification STUDIO JTM ST20C
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
2
WARNING! SAFETY INSTRUCTIONS
Please read this manual carefully before plugging in. Follow all instrucons and heed all warnings.
Warning: before going any further, make sure
that your amp is compable with your mains
electricity supply. If you have any doubt, please
seek help from a qualied technician – your
Marshall dealer can help you with this.
MAINS INPUT & FUSE
The specic mains input voltage rang that your
amp has been manufactured for is indicated on
the rear panel of the amp. Your amp is provided
with a detachable mains (power) lead, which
should be connected to the mains input socket
on the rear panel of the amp. The correct value
and type of mains fuse is specied on the rear
panel of the amp.
Never aempt to bypass the fuse or t one of
the incorrect value or type.
IMPORTANT SET UP INFORMATION
1. When using your amp with one or more
speaker cabinets, make sure that they are
connected to the correct loudspeaker jack
sockets.
Warning: failure to do the above may damage
your amp. When connecng a speaker cabinet
make sure that you use a proper speaker cable.
Never use a screened (shielded) guitar cable for
this purpose.
2. Ensure that the power switch is set to the
o posion and the standby switch is set to
standby.
3. Connect the supplied mains (power) lead
into the mains input on the rear panel rst
and then into an electricity outlet.
4. Ensure that any master, volume and/or
output level controls on the front panel are
set to zero.
5. Plug your guitar into one of the input jack
sockets on the front panel.
6. Turn the front panel power switch on and
wait a couple of minutes.
7. Select between 20W / 5W using the
standby switch.
8. Turn the volume up to your preferred level
and you’re ready to play.
TRANSPORTING YOUR EQUIPMENT
Please ensure that your amp is switched o,
unplugged from the mains electricity supply and
all removable cables have been disconnected
from your equipment before aempng to
move it.
Only move the amp on its own; do not aempt
to move it while it is stacked on top of a cabinet
or other equipment.
ENGLISH

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Marshall Amplification STUDIO JTM ST20C and is the answer not in the manual?

Marshall Amplification STUDIO JTM ST20C Specifications

General IconGeneral
BrandMarshall Amplification
ModelSTUDIO JTM ST20C
CategoryAmplifier
LanguageEnglish

Related product manuals