Marshall Electronics V-LCD70W-SH - Table of Contents

2
Marshall Electronics
V-LCD70W-SH Operation Manual
Table of Contents
1. Installation & Initial Setup...........................................……..... .................. 3
2. Top & Front Panel Features ...................................................................... 4
3. Rear Panel Features ................................................................................. 5
4. Compatible Input Formats ....................................................................... 6
5. Main Menu & Navigation.................................................…... ................... 7
6. Specifications ........................................................................................... 10
7. Sun Hood Installation………................................................….... ............. 11
8. Included Accessories………................................................…...... ........... 11
9. Troubleshooting………................................................…...... ................... 11
10. Maintenance………................................................…...... ........................ 12
11. Warranty………................................................…...... ............................... 13
IMPORTANT SAFETY INSTRUCTIONS:
• Please do not place the display screen towards the ground to avoid scratching the LCD surface.
• Please avoid heavy impact.
• Please do NOT use chemical solutions to clean this product. Simply wipe with a clean soft cloth to
maintain the brightness of the surface.
• Please do not block any vent hole.
• Please follow the instructions and trouble-shooting to adjust the product.
• Internal adjustments or repairs must be performed by a qualied technician.
The V-LCD70W-SH has been tested for conformance to safety regulations
and requirements, and has been certied for international use. However, like
all electronic equipment, the V-LCD70W-SH should be used with care. Please
read and follow the safety instructions to protect yourself from possible injury
and to minimize the risk of damage to the unit.