Marshall Electronics VMV-402-SH - Operation Via Software; System Requirements and Precautions; Initializing Software Control Program

JR101017a
9. Operation Via Software
Marshall Electronics
8
System requirements and precautions
1. When powering off the VMV-402-SH, allow the unit to remain unpowered for at least 5 to 10 seconds
for capacitors to discharge completely before powering on again.
2. The VMV-402-SH software control program is compatible with Microsoft Windows 98, 2000, XP, 7, 8
and 10.
3. Secure the connection between your computer and the VMV-402-SH before loading the control
software.
Initializing the software control program
When clicking on the executable le, the following dialog will pop-up. There are two ways to control the
VMV-402-SH (under Microsoft Windows 7, please run as administrator).
1. RS-232 over USB Port: Use the mini-USB to connect the ports on device and computer. Select the
correct port number and click the Connect button.
2. Ethernet TCP/IP Client / DHCP Port: Enter the IP address (or DHCP) of the device and click the
Connect button.