EasyManua.ls Logo

Martha Stewart Jayco Accent Chair User Manual

Martha Stewart Jayco Accent Chair
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Pre-assembly:
Take out all parts and hardwares from box.
Do not discard any content until assembly completed to avoid accidentally discarding small parts or hardware.
Important safety instructions:
Please read carefully all instructions before assembling the table.
For your safety and ease, assembly by two or more adults is recommended.
Keep instructions for future use.
H1
H2
H3
LEFT
RIGHT
1PC
1PC
1PC
1PC
H4
H5
H6
M8*55MM
1PC
8PCS
2PCS
M8
(Ø8+Ø21*2MM
(Ø8+Ø13)*1.5MM
8PCS
M8*30MM
8PCS
4PCS
Ø25*5MM
H6
H1 H3 H4
100
%
P1
P2
CHAIR BACKREST
CHAIR SEAT
Assemble the chair on a flat, soft surface such as a carpet or cloth to prevent scratching.Turn the
chair seat(P2) upside down, open the zipper, comfirm direction, put chair seat(P2) on the chair
backrest(P1),fully tighten bolts(H1) and washers(H3 and H4 with allen wrench(H6) as illustration
below.
Page 1 of 4
Jayco Accent Chair
Question and Answer IconNeed help?

Do you have a question about the Martha Stewart Jayco Accent Chair and is the answer not in the manual?

Martha Stewart Jayco Accent Chair Specifications

General IconGeneral
BrandMartha Stewart
ModelJayco Accent Chair
CategoryIndoor Furnishing
LanguageEnglish

Summary

Important Safety Instructions

Pre-assembly Preparations

Assembly Steps

Step 1: Attach Chair Backrest to Seat

Assemble chair seat (P2) to backrest (P1) using bolts (H1) and washers (H3, H4) with allen wrench (H6).

Step 2: Attach Foot Gaskets

Apply gasket (H5) to both ends of the chair feet for scratch prevention.

Step 3: Attach Left Leg Frame

Attach left leg frame (P3) to chair seat (P2) using bolts (H2) and washers (H3, H4) with allen wrench (H6).

Step 4: Secure Left Leg Frame

Further tighten bolts (H2) on the left leg frame (P3) using allen wrench (H6).

Step 5: Attach Right Leg Frame

Attach right leg frame (P4) to chair seat (P2) using bolts (H2) and washers (H3, H4) with allen wrench (H6).

Step 6: Secure Right Leg Frame

Further tighten bolts (H2) on the right leg frame (P4) using allen wrench (H6).

Step 7: Final Tightening

Fully tighten all previously installed bolts (H1, H2) and washers (H3, H4) to secure the chair.

Safety Maintenance Note

Related product manuals