Martin EVO - Page 9

Martin Engineering M3796-05/12 5 EVO
®
Return Roller
6. Install lanyard and snap lock pin (E) on hanger tube (D).
7. Slide hanger tube (D) into pivoting weldment (C).
8. Attach hanger tube (D) to stringer using cap screws, washers, and nuts
(A), but do not tighten.
9. Center pivoting weldment (C) on belt and tighten set screws (F).
10. Slide roll assembly (H) on rotating weldment (G). Make sure handle (J)
is located on operator side of conveyor.
11. Insert snap lock pin (E) into rotating weldment to secure roll assembly.
12. Rotate roll assembly into position and lower handle (J).
A. Cap Screw, Washers, and Nut (2 used)
D. Hanger Tube
C. Pivoting Weldment
E. Snap Lock Pin and Lanyard
F. Set Screws (4 used)
G. Rotating Weldment H. Roll Assembly J. Handle
Installation