How do I fix an AURA CALIB ERR on Martin MAC Aura XB?
An 'AURA CALIB ERR' message on Martin DJ Equipment means calibration values cannot be read from the Aura LED PCB. Check the communication wires from the Beam LED PCB to the Aura LED PCB and replace the Aura LED PCB if necessary.
What causes 'EFFECTS TOO COLD' error on Martin MAC Aura XB DJ Equipment?
The 'EFFECTS TOO COLD' error on Martin DJ Equipment is caused by a low ambient temperature. To resolve this, leave the fixture powered on to warm it up, or move it to a warmer location. You can also try updating the firmware.
General| Light Source | LED |
|---|---|
| LED Lifetime | 50, 000 hours |
| Pan | 540° |
| Tilt | 270° |
| Control | DMX, Art-Net, sACN |
Identifies warning symbols and critical safety alerts.
Details precautions against electrical hazards.
Outlines measures to prevent burns and fire hazards.
Advises on preventing eye damage and physical harm.
Navigating menus, setting DMX address, and modes.
Configuring beam, aura, and effect parameters.
Adjusting pan/tilt speed, cooling, and dimming settings.
Interpreting error messages and resolving issues.
To Next Page
