The braking light should be lit up on time as soon
as the rear wheel is braked. If not, adjustment shall
be made by turning the adjusting nut.
With the braking light switch in “ON” position, the
braking light should be lit up. If not, check should
be carried out to see whether the braking lamp,
circuit and switch work normally, Make
replacement if needed.
Caution
For the adjustment of the braking light switch, the brake
needs to be first checked to make sure that the free
operating stroke is ensured within the specified range.
If the braking light switch does not work well, the
designed safety system BOS (Brake Override System)
may not work well, causing problems such as no power
when accelerating the throttle, or still powered even
braked.
Headlamp dimming
Before driving, check the brightness, direction, etc. of
the headlamp.
The adjustment can be made to the headlamp in the left
/ right and vertical directions.
To Next Page