Bolts, nuts and fasteners
All the bolts, nuts and fasteners shall be screwed up as
per the maintenance period table. And check all the
cotter pins, safety gripping gears, locks, etc.
Vehicle washing
Cleaning the motorcycle
To keep a good looking of the covers, please wash your
motorcycle often.
The best way to clean your motorcycle is to use warm
water combining with detergent to mop up the dirt before
using water to clean up.
Attention: If you use high-press water to wash the
motorcycle, please do not point the squirt gun at the
electrical parts, plug, cables, bearings and ECU, etc.
The high press would let the water get into the parts and
lead to the failure of function and premature aging.
-Please use ordinary detergent brands to clean your
motorcycle, for the dirtiest places, please use brush to
clean.
-Plug up the muffler before cleaning with water to
prevent water getting into the inside muffler.
-After cleaning with water, please mop up the
motorcycle with clothing or just dry off. Ride for a
distance until the engine has reached a working
temperature; meanwhile apply brake to evaporate the
water left inside the parts.
- Since the motorcycle cools down, please grease all the
sliding parts and bearings with lubricating oil and butter,
meanwhile grease the oil plug with lubricating oil.
- In order to avoid any sundries getting into the
To Next Page