Maintenance and Adjustment
410/420/430 - 001 8903 U1
UZEL
61
Grease Points
Use HI TEMP EP2 GREASE,
Or
MULTI-PURPOSE LITHIUM #2.
Grease points are located as follows:
Front wheel hubs 2 points.
Front axle pivot pins 2 points.
Front axle swivel pin 2 points.
Brake pedal bearing 1 point.
Lift rods and levelling box 3 points.
Four-wheel drive swivel pins 4 points
Four-wheel drive pivot pin 1 point
Four-wheel drive shaft universal joints 2 points
Four-wheel drive shaft sliding coupling 1 point
Four-wheel drive axle universal joints 2 points
Oil can lubrication
With an oil can lubricate throttle and control linkage every 250 hours.
IMPORTANT: Severe working conditions:
Where tractors are operating arduous work cycles, or when working in areas where there are dusty conditions,
paddy fields, deep water etc., coupled with a lack of maintenance care and low specification fuel and oil, the
intervals of service should be halved, particularly for oil and filter changes
WARNING: Tractor lubricants and greases: No significant hazard when properly used and
in the application for which they were designed. Frequent and/or prolonged skin contact
may give rise to skin irritations. Emergency treatment of acute effects:
*Ingestion: DO NOT induce vomiting. Administer 250 ml (1/2 pint) milk or 50 ml olive oil. Seek medical advice.
*Skin Contact: Remove by wiping, wash with soap and water.
*Inhalation: Saturated vapor non-toxic at room temperature. - Remove from exposure.
*Eye contact: Wash with large amounts of warm water.
To Next Page
Loading...
