Massey Ferguson 6400 - Issue 1
02B02.3
Splitting – Sisu Engine / GBA10 Gearbox
B . Disassembly
Preliminary operations
1. Put on the handbrake if necessary.
Remark
Putting on the handbrake is optional because the Park
Lock mechanism (option) automatically immobilises
the tractor when stationary.
2. Check that the suspended front axle (if fitted) is in
low position and remove the control unit bleed
screw (see chapter 9).
3. Remove the side panels either side of the engine
and the bonnet (if necessary).
Servicing under the tractor
4. Remove the chassis reinforcements (if fitted, see
chapter 2).
5. Remove the guard and the 4WD shafts.
Servicing at the front of the tractor
6. Remove the front weights (if fitted).
Servicing on the right-hand side of the
tractor
7. Remove the footstep.
8. Disconnect and remove first the batteries and then
the support.
9. Disconnect the flexible sleeve (1) (Fig. 1) joined to
the air filter, and remove the vertical exhaust
assembly (including support Fig. 2).
10. Mark then disconnect:
- the cables (positive and negative) on the starter,
- The front differential lock hose at both ends,
- the hose on the steering ram,
- the lubricating hoses (running to and from the
cooler) (Fig. 3).
Fig. 1
Fig. 2
To Next Page
Loading...