MASSEY FERGUSON 6445 - B. Disassembly

Massey Ferguson 6400 - Issue 4.a
2B21.4
Splitting the Sisu engine/GTA1030
B . Disassembly
Preliminary operations
1. Apply the handbrake.
2. Check that the suspended front axle is in lowered
position (if fitted).
3. Remove the bleed screw from the control unit (if
fitted, see chapter 9).
4. Take off:
- the side panels either side of the engine,
- the bonnet.
Servicing under the tractor
5. Mark then disconnect the two ends of the hoses
fixed to the 4 WD transmission shaft guards (front
and rear). Block their openings.
6. Remove the guards and 4 WD transmission shaft.
Servicing at the front of the tractor
7. Remove the front weights (if fitted).
Servicing on the right-hand side of the
tractor
8. Disconnect the batteries.
9. Take off:
- the front mudguard;
- the vertical exhaust assembly (including support)
(Fig. 1);
- the side engine reinforcement;
- the footstep (if necessary).
10. Disconnect the flexible particle suction sleeve (1)
(Fig. 2) between the air filter and the exhaust.
11. Mark and disconnect the starter electrical harness.
12. Remove the starter (if necessary).
MA-02-05125A
Fig. 1
1
MA-02-05126A
Fig. 2
¤
H