MASSEY FERGUSON 6455 - Page 118

Massey Ferguson 6400 - Issue 2
02B01.14
Splitting - Perkins Engine / GBA20 Gearbox
Servicing under the cab
If the engine is still hot, allow it to cool.
Reminder
To work on heating hoses, it is not necessary to drain
the engine block cooling circuit.
40. Toe-in each heating hose using a clamp fitted with
plastic jaws (Fig. 18).
Servicing the engine
41. Mark and disconnect the heating hoses on the
engine block and water pump.
Immediately block the ports using suitable plugs.
42. Disconnect the negative cables on the block at the
rear left-hand side of the engine (Fig. 19).
43. If necessary disconnect the connector (1) of the
main wiring harness (Perkins EEM engine)
(Fig. 19).
44. Detach the air conditioning compressor,
condensor and filter from their respective supports
(if fitted).
Place the assembly beside the tractor without
disconnecting the pipes and hoses (see
chapter 12).
Note: Carry out this procedure with care.
Fig. 18
Fig. 19
¤
H