MASSEY FERGUSON 6465 - Page 100

Massey Ferguson 6400 - Issue 4.a
2A30.8
Splitting the front frame/Sisu engine - MF 6497-6499
27. Remove the suspended front axle control block (if
fitted, see chapter 9).
28. Remove (see chapter 8):
- the first bearing of the fixed or suspended
(according to version) front axle;
- the front axle.
Second step: splitting the front frame (radia-
tors/cooler) from the engine.
29. Correctly sling and balance the front frame
assembly (radiators/cooler), using the tapped holes
drilled into each side of the front frame (Fig. 14).
30. Loosen one M16x85 side screw (1) on the left and
right-hand side of the engine (Fig. 13). Replace
with a guide stud of appropriate length.
31. With the help of an operator, loosen the screws (2)
(3) (Fig. 13).
32. Remove the front frame from the engine.
Screw dimensions (Fig. 13)
Screw
M16x85 (1)
M20x135 (2)
M24x165 (3)
¤
H