MASSEY FERGUSON 6470 - Page 130

Massey Ferguson 6400 - Issue 4.a
2B11.6
Perkins/GTA2520 engine separation
Operations under the cab
CAUTION: If the engine is still hot, allow it to
cool.
N
OTE: To work on heating hoses, it is not necessary to
drain the engine block cooling circuit.
14. Pinch out each heating hose using a clamp fitted
with plastic jaws (Fig. 5).
Operations on the engine
15. If necessary, disconnect the connector (1) of the
main wiring harness (Fig. 6).
16. Separate the compressor, the condenser and the
filter from their respective holders, and remove
them without breaking the circuit (see chapter 12).
N
OTE: Proceed carefully.
Operations at the front of the cab
17. Disconnect the connectors (2) on the left-hand
face of the bulkhead (Fig. 6).
Fig. 5
¤
H