Massey Ferguson 6400 - Issue 1
02B02.5
Splitting – Sisu Engine / GBA10 Gearbox
Servicing at the front of the cab
17. Disconnect the connectors (2) on the left-hand
face of the fire wall (Fig. 5).
18. If necessary, mark and disconnect the steering
ram hoses on the spool valve (orbitrol) (Fig. 6).
Preparing for disassembling
19. Stop the front axle oscillation (all versions) by
sliding a suitable chock in either side of the support
(1) (Fig. 7).
20. Chock the rear wheels.
21. Install (Fig. 9):
- a fixed stand at the front of the gearbox,
- a mobile stand at the back of the engine.
22. If necessary, separate the cab from the front right-
and left-hand supports. Gently lift it using two
straps fitted to the lateral handles. Place a block
temporarily between the cab and the supports.
Disassembly
23. Remove the screws and nuts attaching the engine
to the gearbox (Fig. 8). Mark their lengths and posi-
tionings.
Fig. 6
Fig. 7
To Next Page
Loading...