Massey Ferguson 6400 - Issue 2
02B01.6
Splitting - Perkins Engine / GBA20 Gearbox
Servicing the engine
14. If necessary disconnect the connector (1) of the
main wiring harness (Fig. 5).
15. Separate the compressor, the condenser and the
filter from their respective holders, and remove
them carefully, without breaking the circuit (see
chapter 12).
Remark
Work carefully.
Servicing at the front of the cab
16. Disconnect the connectors (2) on the left-hand
face of the fire wall (Fig. 5).
Preparing for disassembling
17. Cancel the front axle oscillation (all versions) by
sliding a suitable chock in at each side of the
support (1) (Fig. 6).
18. Chock the rear wheels.
19. Install (Fig. 7):
- a fixed stand at the front of the gearbox,
- a mobile stand at the back of the engine.
20. If necessary, separate the cab from the front right-
and left-hand supports. Gently lift it using two
straps fitted to the lateral handles. Fit a wooden
chock temporarily between the cab and the
supports.
Fig. 5
Fig. 6
To Next Page
Loading...