Massey Ferguson 6400 - Issue 2
02A01.7
Splitting - Front frame / Perkins engine
Reassembly
25. Clean the mating faces of the engine and front
frame.
Special point
For tractors fitted with a Perkins six-cylinder engine,
check with a ruler prior to assembly that the supports
(5) are in line with the front face of the lower engine
housing (Fig. 13). If they are not, adjust the support(s)
until they are correctly aligned. Tighten the screws to:
- (4) 240 - 320 Nm (Loctite 270 or equivalent),
- (6) 240 - 320 Nm.
Check correct alignment after tightening.
26. Screw a guide stud onto each rear face of the
frame (Fig. 12).
27. With the help of an operator, assemble the front
frame onto the engine. Take out the guide studs.
28. Fit and tighten the diametrically opposed screws
(Fig. 15) in the following order:
- Screw (2): 480 -640 Nm.
- Screw (3): 800 -1040 Nm.
- Screw (1): 240 -320 Nm.
Final operations
Remark
Final operations are not especially difficult.
They should be carried out in the reverse order to
preliminary operations.
However, it will be necessary during reassembly to
carry out the tightening torques, adjustments and tests
described below.
Tightening torque
As required, wheel screws or nuts (see chapter 6).
Topping-up
- of coolant, to the maximum level marked on the
expansion tank (Fig. 14).
Fig. 12
Fig. 13
To Next Page
Loading...