MASSEY FERGUSON 6495 - B. Disassembly

Massey Ferguson 6400 - Issue 4.a
2A30.4
Splitting the front frame/Sisu engine - MF 6497-6499
B . Disassembly
Preliminary operations
1. Apply the handbrake.
2. Check that the suspended front axle (if fitted) is in
high position.
Position chocks between the upper control arms
and front axle housing (Fig. 1).
3. Remove the bleed screw from the control unit (if
fitted, see chapter 9).
4. Take off:
- the side panels either side of the engine,
- the bonnet (if necessary).
Servicing under the tractor
5. Mark then disconnect the two ends of the hoses
fixed to the 4 WD transmission shaft guards (front
and rear). Block their openings.
6. Remove the guards and 4 WD transmission shaft.
Servicing on the right-hand side of the
tractor
7. Disconnect the batteries.
8. Take off:
- the front mudguard;
- the vertical exhaust assembly (including
support);
- the side engine reinforcement;
- the protection grille close to the radiator.
9. Disconnect:
- the turbocharger outlet air sleeve (1) (Fig. 2);
- the flexible air filter sleeve.
MA-02-05110A
Fig. 1
1
MA-02-05111A
Fig. 2
2
MA-02-05112A
Fig. 3
¤
H