MASSEY FERGUSON 6499 - Page 141

Massey Ferguson 6400 - Issue 4.a
2B11.17
Perkins/GTA2520 engine separation
Operations at the front of the cab
46. Disconnect the connectors (2) and the ground
terminals (1) on the left-hand side of the cab
bulkhead (Fig. 20).
Preparing for disassembly
47. Stop the front axle swinging by sliding a suitable
wooden chock at each side of the support (1)
(Fig. 21).
48. Chock the rear wheels.
49. Install (Fig. 22):
- a fixed stand at the front of the gearbox
- a mobile stand at the rear of the engine
50. If necessary, separate the cab from the front right-
and left-hand supports.
Gently lift the cab front using two straps fitted to
the lateral handles.
Fix the cab in a raised position
Temporarily place a wooden chock between each
support and the cab right- and left-hand
attachments.
Fig. 20
Fig. 21
Fig. 22
¤
H