Massey Ferguson 6400 - Issue 2
02A01.12
Splitting - Front frame / Perkins engine
Preparing for disassembling
46. Stop the front axle oscillation by sliding a suitable
wooden chock either side of the support (1)
(Fig. 22).
47. Chock the rear wheels.
48. Install (Fig. 25):
- a mobile stand under the front axle beam,
- a suitable sling under the front of the frame,
- a fixed axle stand under the engine sump.
Disassembly
Reminder
Before disassembling:
- check that the unions (hoses, pipes and harnesses)
are all disconnected;
- note the position and location of chocks (1) inserted
between the engine sump and front frame (Perkins
EEM engine - Fig. 23).
49. Loosen and remove (Fig. 24):
- for Perkins engine with mechanical injection:
screws and bolts (2), (4) and (1),
- for Perkins EEM engine: screws and bolts (2),
(3), (4) and (1).
With the help of an operator, gradually separate
the engine front frame at the same time (Fig. 25).
When disassembling, also use the
sling to reduce the risk of toppling of the front
frame assembly (Fig. 25).
Fig. 22
Fig. 23
To Next Page
Loading...