Massey Ferguson 6400 - Issue 1
02A02.5
Splitting - Front frame / Sisu engine
18. Disconnect the air sleeve (3)(4) on the air cooler
located inside the grille (Fig. 9).
Preparing for disassembling
19. Cancel the front axle oscillation (all versions) by
sliding a suitable chock in at each side of the
support (1) (Fig. 8).
20. Chock the rear wheels.
21. Install (Fig. 11):
- a mobile stand under the front axle beam,
- a suitable sling under the front of the frame,
- a fixed axle stand under the engine sump.
Disassembling
22. Remove lateral screws (1) (Fig. 10).
23. With the help of an operator, loosen the screws
(2)(3) (Fig.10), simultaneously moving the frame
away from the engine.
When disassembling, use the sling to
reduce the risk of toppling of the front frame assembly.
Screw dimensions
- M16 x 100
- M20 x 150
- M24 x 165
Reminder
When disassembling, check that connections (hoses,
pipes and harnesses) are all disconnected.
Fig. 8
Fig. 9
To Next Page
Loading...