BATTERY & FUSE REPLACEMENT
If “
”appears on display, it indicates that the battery should
be replaced.
Fuse rarely need replacement and blow almost always as a
result of operator’s error.
To replace battery & fuse (200mA/250V) remove the 2 screws
in the bottom of the case. Simply remove the old, and replace
with a new one.
Be careful to observe battery polarity.
WARNING
Before attempting to open the case, always be sure that test
leads have been disconnected from measurement circuits.
Close case and tighten screws completely before using the
meter to avoid electrical shock hazard.
ACCESSORIES
• Operator’s instruction manual
• Set of test leads
• Gift box
• 9 volt battery. NEDA 1604 6F22 006P type
• Holster (option)
-8-
To Next Page
Loading...
Need help?
General
