Mastech MS8232B User Manual

11 12
3. The meter shall display the approximate resistance
value between measured points. Here if the
resistance value between measured points is less
than 50±20Ω,the buzzer will make a sound.
5-5 Capacitance Measurement
Warning
In order to avoid the meter or measured equipment from
being damaged, cut off all power supply of measured
circuits and discharge all capacitors before on/off
measurement.
The method of on/off measurement is:
The capacitance ranges of the meter are:
4.000nF, 40.00nF, 400.0nF, 4.000uF, 40.00uF, 100.0uF.
The method of measuring capacitance is:
1. Turn rotary switch to position, press key and
select measuring range.
2. Apply the two ends of test leads to measure the two
pins of the capacitance under test and read
measured value from LCD.
Ω
Notice:
1. The meter shall take some time to stabilize the
reading when measuring high capacitance.
2. The small capacitance with less than 10nF shall
minus the distribution capacitance of the meter and
lead (namely displayed base number) when
measuring.
The method of measuring frequency is:
1. Turn rotary switch to position.
2. Press key and select Hz range.
3. Apply the two ends of test leads to measure the
frequency value of the circuit under test.
5-6 Frequency Measurement
4. Read frequency value from LCD.
5-7 Duty Cycle Measurement
The method of measuring duty cycle is:
1. Turn rotary switch to position.
2. Press key and select % range.
3. Apply the two ends of test leads to measure the
duty cycle value of the circuit under test.
4. Read frequency value from LCD.
V
Hz%
Hz%
V
Hz%
Hz%
FUNC

Mastech MS8232B Specifications

General

Brand	Mastech
Model	MS8232B
Category	Multimeter
Language	English