10
Product no. 399-6488-6
ATTACHING REGULATOR TO CO
2
TANK
ATTACHING COUPLER TO REGULATOR
3.
2.
1.
2.
Hose
Clamp
ATTACHING COUPLER TO REGULATOR
1.
ATTACHING REGULATOR TO CO
2
TANK
IMPORTANT! When you purchase your first keg of beer, you must also have your CO
2
Tank filled by a local supplier.
CO
2
Tanks can be filled at locations such as welding supply shops, party stores, and wherever kegs are purchased.
If not already inserted, insert the CO
2
Directional Washer into the Keg Coupler.
Then screw the CO
2
Line onto the Keg
Coupler.
Push the other end of the CO
2
Line through
the hole in the rear of the cabinet. Slide a Hose
Clamp onto the end of the CO
2
Line, then attach
the hose to the barb fitting on the bottom of the
regulator. Secure the CO
2
Line by tightening the
Hose Clamp with a flathead screwdriver.
Align and hook the 4 holes of the
CO
2
Tank Holder with the screws
on the back of the unit.
4.
Use an adjustable wrench
(not included) to attach the
Regulator to the CO
2
Tank.
Place the CO
2
Tank into the
CO
2
Tank Holder.
Make sure the white nylon High
Pressure Washer (already installed)
is attached to the Regulator.
To Next Page
Loading...
Need help?
General
