16
Product no. 399-6488-6
CONVERT TO REFRIGERATOR HOW TO OPERATE
2.
1.
3.
HOW TO OPERATE
Follow the steps below to dispense beer from your appliance.
1. Make sure the unit is plugged into a properly grounded AC outlet.
2. Place the Drip Tray under the beer faucet to avoid messes from excess beer.
3. To dispense beer pull the Tap Handle towards you. Refer to the section on Tapping the Beer Keg if the beer
does not dispense.
4. When pouring, hold the glass steady at a 45° angle. When it is 2/3 full, straighten the glass. Ideally, foam should
have a tight creamy head and the collar on an average glass should be ¾” to 1” (2 to 2.5 cm) high.
5. Increase the pressure if the beer runs too slowly (see Setting the Regulator section). Generally, 8-10 PSI is
recommended.
6. Cheers!
4.
To seal off the unit, insert the Top Cabinet Plug into the opening on the top of the
cabinet.
Remove all parts and hoses from the interior and exterior of the unit, including all hoses, the CO
2
Tank and Tap
Tower.
Then insert the CO
2
Hole Plug into the CO
2
Line hole located in the upper left corner
on the back exterior of the cabinet.
Arrange the included Wire Racks in the cabinet interior to fit your refrigeration
needs.
CONVERT TO REFRIGERATOR
Follow these steps to easily convert this appliance into a refrigerator.
To Next Page
Loading...
Need help?
General
