Master Chef 1-Tap Kegerator - TAP TOWER INSTALLATION; ATTACHING COUPLER TO TAP TOWER

9
TM
ATTACHING COUPLER TO TAP TOWER TAP TOWER INSTALLATION
1.
Remove & discard
Insert (rounded
side down)
2.
Tap Tower
3.
3.
1.
TAP TOWER INSTALLATION
Remove all packing tape from the Tap Tower.
2.
ATTACHING COUPLER TO TAP TOWER
Remove the packing spring and Backflow
Stopper from inside the Keg Coupler, then
reinsert the Backflow Stopper into the
Keg Coupler (rounded side down).
Remove the black packing cap from
the top of the Coupler, then place the
Top Coupler Washer flush and centred
on the top of the Keg Coupler.
After the Tap Tower has been placed
on top the cabinet and the hose line
feeds through the bottom, attach the
wing nut to the Keg Coupler.
Guide the Tap Tower Washer up the tap tower
hose and let it sit on the top of the cabinet.
Then feed the tap tower hose through the hole
in the top of the cabinet.
Align the notches at the bottom of the tower
with the hole in the top of the cabinet, then
insert and twist the tower clockwise to lock it
into place (about a ¼ turn).
Tap Tower Washer