6
Product no. 399-6488-6
PARTS
PARTS
Read all instructions carefully before assembling this appliance.
IMPORTANT! Stand this appliance in an upright position for 8-10 hours before plugging into an electrical outlet.
This will allow the coolant in the refrigeration unit to stabilize before turning on the power.
If still unsure whether your appliance has been properly assembled, it is recommended that you contact customer
service, or a qualified installer, such as a brewery or wherever kegs are sold.
Washers / Beer Line Adaptor Parts
NOTE: Most washers are already attached to this appliance. Extra parts are included in a plastic bag. Refer to the
parts diagram and corresponding part numbers to understand where each washer / extra parts belong.
Hose Clamps
(Part 4)
Body Seal Coupler
Washer (38 mm)
(Part 5)
Probe Seal Coupler
Washer (22 mm)
(Part 5)
Tap Tower
Washer (24 mm)
(Part 1)
Spigot Handle
Washer (15 mm)
(Part 2)
Inner Probe Seal
Coupler Washer
(23 mm)
(Part 5)
Tap Tower Spigot
Washer (13 mm)
(Part 3)
Top Coupler Washer
(20 mm)
(Part 5)
Regulator High Pressure
Washer (18 mm)
(Part 6)
CO
2
Hole Plug
(Exterior Cabinet)
CO
2
Directional
Washer
(Part 5)
Metal Washer
Qty. 2
(Part 11)
Backflow Stopper
(Part 5)
Tap Tower Washer
(Part 1)
To Next Page
Loading...
Need help?
General
