Master cook SRGG806 - Burner and Regulator Installation; Burner and Wind Guard Assembly

8
Assembly Instructions
5
Place burner(F) into bottom bowl(H) corresponding position
and fix it with 1pc M6x16 bolt(BB), 1pc
(DD) and 1pc Ø6.4 steel lock
Ø6.4 steel washer
washer(GG).
6
Attach wing guard to burner end by hand. Then
finger-tighten regulator/control valve to burner end.
Note: Once attached, the regulator/control valve will
freely rotate to accomodate for the LP gas tank.
Hardware Used
DD
GG
Screw
Lock washer
1pc
1pc
DD
F
H
GG
BB
Bolt
1pc
BB