e
13. Align the holes in the hinges of the two
doors (X and Y) with the two skirts (V and Z),
insert flat head screws (DD) into the holes,
and then tighten. (Fig. 13)
14. Align the holes in the main beam (W)
with side panels (P and AB) and two skirts
(V and Z), insert screws (BB) into the holes,
and then tighten.
There are four screws to connect the side
panels and two screws to connect the skirts.
(Fig. 14)
Hardware Used
1/4-20 x 5/8 in.
Screw
X 6
BB
Hardware Used
Flat Head 5/32-32
x 1/2 in. Screw
X 8
DD
Y
X
DD
13
V
Z
P
W
14
V
Z
BB
AB
To Next Page
Loading...
