27
Lowes.com/masterforge
OPPERATING INSTRUCTIONS
WARNING:
1. Make sure the hood is completely open each time you attempt to light the grill.
Failure to open the hood could lead to delayed ignition resulting in bodily harm.
2. This grill is equipped with a ame-observation hole in the side panel. Wear
protective mitts before using the ame watch.
CAUTION: It is important to inspect the full length of the gas line hose. If it is evident
there is excessive abrasion or wear, or the hose is cut, the hose must be replaced prior
to the appliance being used.
If required, check your parts list for the proper replacement hose assembly. It will be
necessary to open the bottom door to fully inspect the hose.
Match Lighting Instructions
Important: The hood must be open when match lighting any burner.
1. Turn on gas supply.
a. If portable, at the LP cylinder valve.
b. If permanent gas supply, at the manual gas shutoff valve.
2. Locate the ame observation holes on each side.
3. Open the right door to access the match clip with chain.
4. Attach either the match or paper to the clip shown in Fig. 28, light the match and insert it
close to the ports of the burner, push and turn the depressed knob to the left to “HIGH”
position.
5. The center burner (if needed) can be lit from center grid by inserting the match clip into
the front side of avor step tent. Light this burner before igniting both outside burners.
6. Depress burner valve for that burner and turn to high.
7. Observe that the burner has ignited. Remove the match and extinguish.
8. Repeat Steps 2-6 for the next burner.
Match
Paper
To Next Page
Loading...
Need help?
General
