15
DO NOT DIVE.
ELECTRICAL INSTALLATION REQUIREMENTS
ELECTRICAL INSTALLATION REQUIREMENTS
!! TRAINER 19 !!
HAVE YOUR ELECTRICIAN READ THE FOLLOWING INFORMATION
BEFORE INSTALLATION BEGINS
The Trainer 19 swim spa requires two separate electrical power supplies.
A 50 amp dedicated electrical service using #6 AWG copper wire with #8 AWG
ground wire should be ran to the Spa Control Pack in the swim spa. This electrical
supply should have an external GFCI installed. (See electrical hook-up diagram on page
16).
A 30 amp dedicated electrical service using #8 AWG copper wire with #10 AWG
ground wire should be ran to the Swim Control Pack in the swim spa. This electrical
supply must be protected by an external GFCI (see electrical hook-up diagram
on page 16).
To Next Page
Loading...
