DELUXE FUSION AUDIO SYSTEM
51
DO NOT DIVE.
Warning: Never remain in your swim spa longer than 15 minutes per session when the water
temperature is above 98˚F. If you wish to spend more time in your swim spa, whether enjoying
music, or just lounging, be sure to keep the swim spa water at or below body temperature (98.6˚F).
*Please refer to your stereo Owner’s Manual for specific operations.
Optional Stereo Docking Station
Your swim spa is equipped with an iPod™ docking station that will allow you to listen to personal selec-
tions through the audio system of the swim spa. This audio system also has an FM only radio receiver
that can be used to listen to local FM broadcasts. Due to varying signal conditions the FM radio recep-
tion may be limited.
The docking station is compatible with most iPod™ products. Master Spas, Inc. does not guarantee
compatibility with all iPod™ products due to software changes and upgrades.
The wireless remote provided with the swim spa is water resistant, but should never be left in the swim
spa when not in use.
Remote Synchronizing
1. Turn the docking station OFF with the on/off button inside the door
(the red LED should not be illuminated when power is OFF).
2. Press the red (POWER) button on the remote.
3. Turn the docking station ON with the on/off button inside door (the red LED will illuminate when
power is ON).
4. Press and hold the (MODE) button on the top right corner. Hold for 10 seconds.
5. The remote’s LCD should read WELCOME or show a mode position such as RADIO, IPOD, or AUX IN.
If the pairing process is not effective, turn the docking station OFF with the on/off button, located inside
the door of the dock. Uplug the 12-pin harness on the back of the stereo for 3 minutes. Reattach the
harness and repeat steps 1-5 above.
If the LCD displays “- -” in either mode, this means that your remote control is out of reception range.
Please move closer and try the feature again.
Each Digital Media Locker™ comes with a matching RF (Radio Frequency) Wireless LCD remote control.
This remote is required to use any functions on the unit. For any additional remote controls you will
need to activate/synchronize those remote controls to the AQ-DM-4 by following the steps above.
If you lose your remote control and buy a replacement, follow the steps above to pair/synchronize
before normal usage.
To Next Page
Loading...
