SWIM SPA TROUBLE SHOOTING GUIDE
SWIM SPA NOT HEATING
* If the swim spas heater has failed, the majority of the time it will trip the GFCI breaker. If the swim
spa is not heating and has not tripped the breaker, please follow these steps:
1. Check the control panel for diagnostic messages. Refer to your swim spa models diagnostic message
area in previous sections. Follow steps to alleviate message.
2. Check water set temperature at control panel.
3. Check for dirty filters. Clean if necessary.
4. Check the “heat mode” that the swim spa is set in. The swim spa should be set in the ready mode
depending on the model.
5. Check the control panel for heat light indicator. If the light is on and not blinking the swim spa
should be heating. Wait a reasonable amount of time (approximately 1 hour) to see if the water
temperature is rising.
6. Check to make sure that the pump is primed and all slice valves are open.
7. Reset power to the swim spa at GFCI breaker.
8. If swim spa is still not heating, contact your dealer for service.
GFCI IS TRIPPING
A ground fault circuit interrupter (GFCI) is required by the National Electrical Code for your protection.
The tripping of the GFCI may be caused by a component on the swim spa or by an electrical problem.
Electrical problems include but are not limited to, a faulty GFCI breaker, swim spa component, power
fluctuations, or improper wiring. It may be necessary to contact an electrician if your dealer recommends
doing so.
54
DO NOT DIVE.
To Next Page
Loading...
