15
• Avoid bumping or impacting grill.
• Keep your hands, hair and face away from burning charcoal.
• This grill has an open flame. Be careful of loose hair and clothing during operation. They may
catch fire.
• Use protective gloves when handling this grill or working with fire. Use protective gloves or
long, sturdy fireplace tools when adding wood or charcoal.
• Do not allow anyone to conduct activities around this grill during or following its use until the
unit has cooled. This grill is HOT during operation and remains HOT for a period of time
following its use.
• Fatty foods like hamburgers can have excess grease that can cause flare ups. When cooking
fatty foods, use caution when opening lid and during cooking to avoid being burned.
• Be careful when removing food from grill. All surfaces are HOT and may cause burns. Use
protective gloves or long, sturdy cooking tools.
• Never use glass, plastic or ceramic cookware on this grill.
• The use of alcohol, prescription or non-prescription drugs may impair the user’s ability to
properly assemble or safely operate this grill.
• Grill lid and body are HOT while in use and during cooling process.
• Do not remove adjustable charcoal pan while ashes and charcoal are HOT.
• Air dampers are HOT while the grill is in use and during cooling; wear protective gloves when
adjusting.
• Never overfill charcoal pan. This can cause serious injury as well as damage the unit.
• Only use charcoal lighting fluid, never use gasoline, alcohol or other highly volatile fluids to
ignite the charcoal. These fluids can explode causing injury or death.
REMINDER:NEVER OPERATE THIS GRILL UNDER ANY OVERHEAD CONSTRUCTION.
MAINTAIN A MINIMUM DISTANCE OF 10 FEET FROM OVERHEAD CONSTRUCTION, WALLS
OR RAILS. SEE DIAGRAM BELOW.
Wall
Rails
Overhead
Construction
10 ft. (3m)
10 ft. (3m)
GRILL OPERATION CAUTIONS
STEP 3.
Attach leg bracket (7) to right short
legs (8) as shown using phillips head
screws (A) and hex flange nuts (B).
Repeat step 3 on opposite side.
Do not fully tighten screws at this
time.
6
A
8
B
7
STEP 4.
Insert axle (11) through holes on
short right legs (8). Slide wheel (12)
onto axle and secure using cotter clip
(E). Snap axle cap (H) onto end of
wheel assembly as shown.
Repeat step on opposite side for
remaining wheel.
Do not fully tighten screws at this
time.
11
12
E
H
8
To Next Page
Loading...
Need help?
General
