Masterbuilt 20042011 - Assembly Instructions (Continued); Step 3 - Attaching Leg Brackets; Step 4 - Installing Wheels

STEP3.
Atta¢._ Ieg bracket (7) to right short
legs (8) as shown using phimps hea6
screws (A) and he× flange nuts (B).
Repeat step 3 on opposite side.
Do not fully tighten screws at this
time,
STEP 4.
Insert axle (11) through holeson
short right legs (8), Slide wheel (12)
onto axle end secure using cotter clip
(E), Snap axle cap (H) ontoend of
wheel assemblyas shown.
Repeat step on opposite side for
remaining wheel.
Do not fully tighten screws at this
time.